GPS Bluetooth
GPS Mouse
Navigator
Personal Tracker
GPS Engine Board
Other

EB707 Product Features

Large Photo
  • Build on high performance, low-power SiRF star III chipset
  • Extreme fast TTFF (the time to first fix) at low signal level
  • 20 ¡VChannel GPS receiver
  • SBAS (WAAS, EGNOS Euro Geostationary Navigation Overlay Service) support
  • Full navigation accuracy provided by Standard Positioning Service (SPS)
  • Reception frequency 1575.42MHz
  • CPU (ARM7TDMI) with 4Mb of internally packaged Flash memory
  • Advanced Power Management. (The mode of low power management when signal levels areless than 30dB Hz. Update rates arelimited from 10 seconds to 255 seconds.)
  • Support standard NMEA 0183 protocol
  • Internal RTC (Real Time Clock)
  • Build-in +3~+5V DC converter
  • Compact Engine Board Size 28 x 20x 3.0mm (WxLxH) without patch antenna
  • Shielding case included


Driver / Manual / Specification

Performance

Acquisition time (open sky and stationary)

Reacquisition Average 0.1 seconds
Hot start Average < 1 seconds
Warm start Average 38 seconds
Cold start Average 42 seconds
Accuracy Position 10 meters RMS without SA
Sensitivity Tracking -159 dBm (average)
Acquisition -143 dBm (average)
Dynamics Altitude < 18000 meter maximum
Velocity < 515 m/sec
Acceleration < 4 g
Frequency L1, 1575.42MHz C/A code
Power Consumption Under 65mA fully active
Power Management Advanced Power Management. (The mode of low power management when signal levels are less than 30dB Hz. Update rates are limited from 10 seconds to255 seconds)

Power & Interface characteristics
Baud rate

Default baud rate for SSIII NMEA is 4800 baud. The default serial port settings for SiRF binary mode is 57600, N,8,1.

I/O Protocol NMEA0183 (default)
I/O Connector 14pin SMD type RF Connector¡@ ¡@SMD PAD for Patch Antenna

Physical characteristics

Dimensions

28(L)*20(W)*3.0(H)+/-0.1mm
Weight 4g

Environment conditions

Operating temperature

-20¢XC ~ +80¢XC
Storage temperature -20¢XC ~ +85¢XC
Operating humidity 5% ~ 95% RH, non condensing

Assignment of Connector
PIN Description
1 GND Ground
2 RF_IN Connect to Patch or Active Antenna
3 GND Ground
4 GND Ground
5 GND Ground
6 GND Ground
7 VCC Main power Vcc (3.0V)
8 VBAT Battery backup input. 2.8V to 3.3V ,10uA typical
9 GPIO15

LED indicate for GPS status
10 TX Serial Data output port A
11 RX Serial Data intput port A
12 BOOT_SET Reserved for re-programming flash(pull high)
13 GND Ground
14 GND Ground


2006 Compass Systems Corp. All Rights Reserved / Best viewed under 1024 x 768 modes.