Build on high performance, low-power SiRF star III chipset
Extreme fast TTFF (the time to first fix) at low signal level
20 ¡Vchannel GPS receiver
SBAS (WAAS, EGNOS Euro Geostationary Navigation Overlay Service) support
Full navigation accuracy provided by Standard Positioning Service (SPS)
Reception frequency 1575.42MHz
CPU (ARM7TDMI) with 4Mb of internally packaged Flash memory
Advanced Power Management. (The mode of low power management when signal levels areless than 30dB Hz. Update rates arelimited from 10 seconds to 255 seconds.)
2 UARTS, high speed serial bus
Support standard NMEA 0183 protocol (Version. 3.0 GGA, GSA, GSV, RMC, VTG)
Internal RTC (Real Time Clock)
Build-in +3~5V DC converter
Include MMCX RF connector
Include 6 pins connector
Compact Engine Board Size 27.5 x 26 x 9.5mm (L x W x H)
Shielding case including
Driver / Manual / Specification
Performance
Acquisition time (open sky and stationary)
Reacquisition
Average 0.1 sec
Hot start
< Average 1 seconds
Warm start
< Average 38 seconds
Cold start
< Average 42 seconds
Accuracy
Position
10 meters RMS without SA
Velocity
0.1 meters/second, without SA
Time
1 microsecond synchronized to GPS time
Datum
WGS-84 (or by demand)
Sensitivity
Tracking
-159 dBm (average)
Dynamics
Altitude
< 18000 meter
Velocity
< 515 m/sec
Acceleration
< 4 g
Frequency
L1, 1575.42MHz C/A code
Power Consumption
Under 65mA fully active
Power & Interface characteristics
Serial I/O port
2 UART S, high speed serial bus
I/O Protocol
NMEA 0183 (default)
Baud rate
Default baud rate for SSIII NMEA is 4800 baud. The default serial port settings for SiRF binary mode is 57600, N, 8, 1.
I/O Connector
6 pin type
RF Connector
MMCX type
¡@¡@
Physical characteristics
Dimensions
27.5 ( L ) X 26 ( W ) X 9.5 ( H ) mm w/o patch antenna
Weight
4g
Environment conditions
Operating temperature
-20¢XC ~ +80¢XC
Storage temperature
-20¢XC ~ +85¢XC
Operating humidity
5% ~ 95% RH, Non condensing
Assignment of Connector
PIN
Description
1
VCC IN
+ 3.0~5Vdc power input (System Power)
2
TXA
Serial Data output port A
3
RXA
Serial Data input port A
4
RXB
Serial Data input port B for user's application (not currently used).
5
GND
Power GND
6
TIMEMARK or RESET
TIMEMARK : 1PPS Time mark output
RESET : Active Low reset input(option)
2006 Compass Systems Corp. All Rights Reserved / Best viewed under 1024 x 768 modes.